megaraid bios_如何使用新磁盘在MegaRAID BIOS中设置RAID0
megaraid bios
The LSI MegaRAID is widely used like in IBM x3620M3 servers. This post introduces the process with screenshots of how to configure the new disks and set up RAID0 in the MegaRAID BIOS for reference by other and myself. It is illustrated with one example by adding a new 2TB hard disk and creating a new RAID0 with the disk only (yes, we do this to expose the raw disk to the Linux OS).
LSI MegaRAID与IBM x3620M3服务器一样被广泛使用。 这篇文章介绍了该过程，并提供了有关如何配置新磁盘和在MegaRAID BIOS中设置RAID0的屏幕截图的信息，以供他人和本人参考。 通过添加一个新的2TB硬盘并仅使用该磁盘创建一个新的RAID0来举例说明（是的，我们这样做是将原始磁盘公开给Linux OS）。
There are two major steps with minor steps in each.
有两个主要步骤，每个步骤都有次要步骤。
将磁盘设置为Unconf良好状态∞ (Setting the disk into Unconf Good status ∞)
Enter the Physical View; Choose the corresponding disk and press ENTER:
进入物理视图； 选择相应的磁盘，然后按Enter：
Choose the Make Unconf Good status and click Go:
选择“设置为无效状态”，然后单击“执行”：
Then you can find the new installed drive:
然后，您可以找到新安装的驱动器：
设置磁盘成RAID0 ∞ (Setting up the disk into RAID0 ∞)
Enter Configuration Wizard interface from the Home. If you want to keep the original configuration, choose Add configuration:
从主页进入配置向导界面。 如果要保留原始配置，请选择添加配置：
Choose Manual Configuration:
选择手动配置：
Choose your disk on the left, and click Add to array.
选择左侧的磁盘，然后单击“添加到阵列”。
It will add the disks into a new group on the right. Then click Accept DG:
它将把磁盘添加到右侧的新组中。 然后单击接受DG：
Click next and in click Add to SPAN and click next:
单击下一步，然后单击添加到SPAN，然后单击下一步：
Choose Accept for the RAID configuration:
为RAID配置选择“接受”：
And choose Yes for configuration. Then you can review the configuration and click Accept if it is correct:
然后选择是进行配置。 然后，您可以查看配置，如果正确，请单击“接受”：
It will ask your configuration too. In the Home screen, you can find the new drive online:
它也会询问您的配置。 在主屏幕中，您可以在线找到新驱动器：
And you can find the new disk in Linux after rebooting:
重新启动后，您可以在Linux中找到新磁盘：
megaraid bios